https://bugzilla.novell.com/show_bug.cgi?id=205697 ------- Comment #5 from gdoig@pcug.org.au 2006-09-15 23:54 MST ------- Issue is fixed (here is how this was done). Info from here http://gentoo-wiki.com/HARDWARE_RTL8168 driver version 1.04 Sections used (TROUBLESHOOTING) search the following (line 51-53): edit the file r1000_n.c MODULE_PARM (speed, "1-" __MODULE_STRING(MAX_UNITS) "i"); MODULE_PARM (duplex, "1-" __MODULE_STRING(MAX_UNITS) "i"); MODULE_PARM (autoneg, "1-" __MODULE_STRING(MAX_UNITS) "i"); and change it to: MODULE_PARM_DESC (speed, "1-" __MODULE_STRING(MAX_UNITS) "i"); MODULE_PARM_DESC (duplex, "1-" __MODULE_STRING(MAX_UNITS) "i"); MODULE_PARM_DESC (autoneg, "1-" __MODULE_STRING(MAX_UNITS) "i"); # make clean modules # make install # depmod -a part of dmesg log eth1: no IPv6 routers present ====================== eth0: Identified chip type is 'RTL8168B/8111B'. eth0: r10001.04, the Linux device driver for Realtek Ethernet Controllers at 0xc800, 00:18:f3:3b:93:52, IRQ 11 Realtek RTL8168/8111 Family PCI-E Gigabit Ethernet Network Adapter Driver version:1.04 Released date:2006/07/07 Link Status:Linked Link Speed:100Mbps Duplex mode:Full-Duplex I/O Base:0xC800(I/O port) IRQ:11 . . . . eth0 renamed to eth1 bcm43xx: module not supported by Novell, setting U taint flag. bcm43xx driver -- Configure bugmail: https://bugzilla.novell.com/userprefs.cgi?tab=email ------- You are receiving this mail because: ------- You are on the CC list for the bug, or are watching someone who is.