Not really what I was talking about. Sorry if I wasn't complete enough on my problem. I am installing openSUSE 10.2 at the end of the installation I clone the system for autoyast installations. When I open Yast>misc>installations, I attempt to load, change then save the autoinst.xml file under /root. Yast gives me the error that the file fails the validity test. I attempt to load this file as my installation source and it fails again, warning that it is not a valid installation set. Has anyone seen this? On Mon, 2007-09-17 at 23:20 +0200, Hylton Conacher (ZR1HPC) wrote:
325554 --
CONFIDENTIALITY This e-mail message and any attachments thereto, is intended only for use by the addressee(s) named herein and may contain legally privileged and/or confidential information. If you are not the intended recipient of this e-mail message, you are hereby notified that any dissemination, distribution or copying of this e-mail message, and any attachments thereto, is strictly prohibited. If you have received this e-mail message in error, please immediately notify the sender and permanently delete the original and any copies of this email and any prints thereof. ABSENT AN EXPRESS STATEMENT TO THE CONTRARY HEREINABOVE, THIS E-MAIL IS NOT INTENDED AS A SUBSTITUTE FOR A WRITING. Notwithstanding the Uniform Electronic Transactions Act or the applicability of any other law of similar substance and effect, absent an express statement to the contrary hereinabove, this e-mail message its contents, and any attachments hereto are not intended to represent an offer or acceptance to enter into a contract and are not otherwise intended to bind the sender, Sanmina-SCI Corporation (or any of its subsidiaries), or any other person or entity. -- To unsubscribe, e-mail: opensuse+unsubscribe@opensuse.org For additional commands, e-mail: opensuse+help@opensuse.org