Hi Steve, -----Original Message----- From: Steve Sheriff [SMTP:fsanta@arrakis.es] Sent: Friday, April 07, 2000 1:37 PM
Hi everyone.
After 4 weeks of trying I have finally got a Astra Umax 2200SU on my desk. Works fine under windoze. Nothing under SuSE 6.3 though.
Could someone help me through what is needed next? I see generic scsi loaded as a module in menuconfig but no support for aix7xxx. Is this the one I need? In which case could someone tell me how to install this as a module? I do not have the manual available (lent to friend to install over weekend!)
Which scsi controller do you have? The aic7xxx module works for most adaptec 29xx cards and a few of others, except the 2920. Did you already roll your own kernel or are you using a SuSE kernel? I ask because if you only need modular support the chances are that the proper module is already there.
Or am I missing something simple here?
Did you edit modules.conf so the scsi line reads alias scsi_hostadapter aic7xxx (assuming that's the right module of course) Tim
Yast will not go any further on scanner install since it can't find any scsi devices. The boot up sequence gives:
scsi : 0 hosts scsi : detected total
And, no surprize, SANE can't see it either.
-- To unsubscribe send e-mail to suse-linux-e-unsubscribe@suse.com For additional commands send e-mail to suse-linux-e-help@suse.com Also check the FAQ at http://www.suse.com/Support/Doku/FAQ/