Hi Jan,still having some problems This the output from isdnctrl addif ippp0 and so on and isdnctrl list ippp0 -------------- ippp0 added Layer-2-Protocol for ippp0 is hdlc Encapsulation for ippp0 is syncppp EAZ/MSN for ippp0 is 8768 Current setup of interface 'ippp0': EAZ/MSN: 8768 Phone number(s): Outgoing: 0860922000 Incoming: Dial mode: manual Secure: off Callback: off Reject before Callback: on Callback-delay: 5 Dialmax: 1 Hangup-Timeout: 10 Incoming-Hangup: on ChargeHangup: off Charge-Units: 0 Charge-Interval: 0 Layer-2-Protocol: hdlc Layer-3-Protocol: trans Encapsulation: syncppp Slave Interface: None ------------------------------- But when I do /etc/init.d/net.ippp0 start it's still the same: *Loading isdnctrl configuration ... Section 'ISDNCTRL' has no entry 'INTERFACES' *ERROR: Problem starting needed services. * "net.ippp0" was not started. Maybe you have an idea what still can be wrong? Gruss, jaap Le Mercredi 13 Août 2003 13:49, vous avez écrit :
Ho,
jaap schrieb:
Hi
Ok things are going a bit better now thanks to Jan's mails. I put the next line in /etc/modules.autoload: hisax type=18 protocol=2 id=HiSax0 (for an elsa 1000pci-card) Now at startup hisax starts and the isdn-device files are there.
Good.
But when the script /etc/init.d/net.ippp0 is run at startup or with /etc/init.d/net.ippp0 start I get
*Loading isdnctrl configuration ... Section 'ISDNCTRL' has no entry 'INTERFACES' *ERROR: Problem starting needed services. * "net.ippp0" was not started.
I'm working on it but I didn't find out yet how to proceed for making isdnctrl load a good configuration.
You just use isdnctrl. With no parameters isdnctrl gives you a list of all parameters it has. Also look at 'man isdnctrl'. You should create at least one interface (ippp0) with an outgoing telephone-number, layer2-protocol hdlc, encapsulation syncppp, your MSN and an appropriate hup-timeout. Default for this is 10 seconds which is a little low, I think.
Afterwards just try to start /etc/init.d/net.ippp0 start again.
Gruß Jan