On Friday 15 September 2006 15:11, Michael Schroeder wrote:
On Fri, Sep 15, 2006 at 02:57:43PM +0200, Dennis Sieben wrote:
Dear buildserver maintainers,
I finally started my first project in the buildservice. But only a src.rpm is build. It looks to me like all sections below %prep aren't used. Normally I would expect a line like "Executing(%prep)" after the setup of the build environment. But this doesn't happen. Maybe one can take a look at this. This happens in the package gstreamer-plugins-moodbar in home:d7. Maybe it's just a fault of me because I'm quite new to the buildservice.
Your specfile contains an error:
%define gstlibdir %{_libdir]/gstreamer-%{gst_major_ver} ^^^^^^^^^^
this should be '}' instead if ']'...
Yes that was it. Thanks. Is there any chance that these syntax errors can be detected inside the buildservice? If the buildservice could give an error message like syntax error in spec file it would be fine. Just building the src.rpm leaves open too many possible reasons. Regards, Dennis Sieben