https://bugzilla.novell.com/show_bug.cgi?id=880896
https://bugzilla.novell.com/show_bug.cgi?id=880896#c3
--- Comment #3 from Dieter Jurzitza 2014-06-03 15:23:03 UTC ---
Thank you for your valuable comments. I have to state that I was not precise
enough saying that I was going to use the version from factory - yes, I would,
after having compiled on 13.1, what IMHO should not cause any issues (and if it
would I wouldn't install it anyway ....). I did not know about the "Printer"
directory within the "repositories" directory. Very good hint.
Nevertheless, as stated before, I will test the latest version from factory
with the laserjet 1018 - being a high quality printer or not. IMHO, at the end
of the day the question ought to be what consequences arise for the final user.
If (!) the version from factory is going to do the job I am still convinced
that it might be a good idea to update what is distributed through 13.1. The
hplip maintainers are capable to fix what is going on with hplip, but they
cannot modify what is distributed with openSUSE.
Nevertheless this will take a decent amount of time now as I will not get
access to this printer prior to the end of June. I'll be back as soon as I know
more ....
Thank you again for looking into this,
take care
Dieter Jurzitza
--
Configure bugmail: https://bugzilla.novell.com/userprefs.cgi?tab=email
------- You are receiving this mail because: -------
You are on the CC list for the bug.