http://bugzilla.novell.com/show_bug.cgi?id=540609
User jsmeix@novell.com added comment
http://bugzilla.novell.com/show_bug.cgi?id=540609#c10
Johannes Meixner changed:
What |Removed |Added
----------------------------------------------------------------------------
Status|NEW |NEEDINFO
Info Provider| |diego.ercolani@gmail.com
--- Comment #10 from Johannes Meixner 2009-09-25 04:30:20 MDT ---
Thanks again for the well labelled images!
As far as I see,
*ImageableArea A4Duplex/A4 AutoDuplex 210x297mm): "9.00 60.00 586.00 797.00"
has the expected effect that the bottom line is now higher
so that it is printed even in duplex mode.
But there is the unexpected effect that on the back page
the upper part (which would contain the word "World") is cut.
Therefore the top coordinate of the imageable area should
be less so that on the back page the upper part might be
hopefully shown then, i.e. something like
*ImageableArea A4Duplex/A4 AutoDuplex 210x297mm): "9.00 60.00 586.00 767.00"
The general idea is to start with any sufficiently small
imageable area so that all content is printed in duplex mode
and then one can increase the imageable area again
step by step to find the maximum imageable area where
still all content is printable even in duplex mode.
Note that small differences like 0.5mm are most likely
only because the mechanical paper feed of the printer
is not very accurate.
Therefore be on the safe side with the imageable area
and have it about 1mm = 3 PostScript points
smaller than what is theoretically possible e.g. instead of
"9.00 40.00 586.00 787.00" use "12.00 43.00 583.00 784.00".
If you find an imageable area where all content is printable
even in duplex mode, please provide feedback.
Many thanks in advance.
--
Configure bugmail: http://bugzilla.novell.com/userprefs.cgi?tab=email
------- You are receiving this mail because: -------
You are on the CC list for the bug.