https://bugzilla.novell.com/show_bug.cgi?id=252368 ------- Comment #4 from kelvin@zft.co.uk 2007-03-08 04:44 MST ------- This is a PC with an Aopen "Modt" "i945GTt-VFA" motherboard (Intel 945GT + ICH7MDH chipset). It is connected to an Iiyama diaplay. I added the data to videobios and confirm that it runs at boot showing "OK". The change had no effect on the video resolutions offered by the OpenSuSE 10.2 control panel Screen Resolution conrtol (1280 max). The refresh rate offered also shows as 75Hz even though this is an LCD display attached via a DVI connector. The Yast SAX2 control still lets me set up 1600x1200, but at the test screen shows 1280x1024 and that's what I end up with. I tried several settings over 1280x1024 and various colour depths and had no success. The only effect of the videobios change seems to be when gdm starts. The screen blanks and a multicolored bar appears across the bottom +/- 5% of the screen. Before the change this as a simple bar; after the change the bar was shortened. So there was an effect, but SAX2 cannot seem to take advantage of this. Thanks for your help so far! -- Configure bugmail: https://bugzilla.novell.com/userprefs.cgi?tab=email ------- You are receiving this mail because: ------- You are on the CC list for the bug, or are watching someone who is.