On May 26, 06 13:24:46 +0100, Phil Betts wrote:
Matthias Hopf wrote on Friday, May 26, 2006 12:03 PM::
On May 26, 06 02:22:22 +0200, Dieter Jurzitza wrote:
402 MHz is a little bit too much for my poor monitor (carefully speaking). So, ATI-developers, there is still some work to be done!
Anlog monitors don't have an upper limit for dot clocks. They have a bandwidth that describes with which frequency the signal will start degrading. No hard limit.
I was about to make the same point myself, however, I think there is still a problem with the modeline generated by sax2.
401.86 MHz / 2240 = 179.4 kHz horizontal frequency 179.4 kHz / 1300 = 138 Hz vertical refresh rate
These frequencies are high for most, if not all, monitors.
You were talking about 9.3. This is pretty old.
Or did you update the sax2 packages to current ones? I doubt they will
install and run cleanly on 9.3.
CU
Matthias
--
Matthias Hopf