Dual head functioning in 9.1,9.2,9.3 as follows: ati 9200 with dvi and vga outputs. 19" samsung syncmaster 910t digital lcd 22" viewsonic p225f pro crt I've had a dual head configuration working since 9.1. I've upgraded thsi same box through 9.2 and 9.3. Each time I had to use the old config file from 9.1 to get my dual head configuration working again. I just upgraded this same box to 10 and I can not get my dual head configuration working now. Worse, it appears that sax2 has removed much of the functionality of the previous versions. In previous versions, I could add/delete a particular video card. With 10, I have no such option. It identifies the proper card, ati 9200, but does not see the second output. The only way I can get sax2 to 'see' two video is to manually edit the xorg.conf file. I'm up to it, but can't get it to work. After fighting with it for a while, it suddenly properly identifies my samsung monitor and I have finally got it to properly recognize the viewsonic, yet when X starts, the secondary monitor (viewsonic) does not get a signal. The only warnings I receive in the log file are: (WW) Open APM failed (/dev/apm_bios) (No such file or directory) . . (WW) RADEON(0): Failed to detect secondary monitor, MergedFB/Clone mode disabled . . I assume the last one might have something to do with it, although when the box starts up, the console is displayed on the secondary (viewsonic) monitor. When X runs, it's on the primary (samsung). Any suggestions would be wonderful. -- Until later, Geoffrey