[SLE] Newbie Linksys EG1032 1000 Mbps
VERY new to Linux and SuSE. SuSE 8.2 i386 purchased Trying to install EG1032 network card. Card is identified as a NS82030 (I think that's right) and that driver is loaded (is that the right term?). There is an onboard NIC (eth0) as well that I have yet to get disabled (jumper on the board somewhere). It works fine. If I plug the network cable into the EG1032 it gets an IP address during boot but I cannot connect to the internet. I have read on other groups that the NS82030 driver works in SuSE (not sure of the build) but I'm not having any luck. Are there some standard settings I can try? And how would I make them and/or where would I find the info. Thanks Mark B
We need a little more info, are you using a router or are you plugging directly into a cable/dsl modem? You say you get an ip but cannot get anywhere on the internet, can you go to websites via ip addresses? Try this http://66.35.250.150/ that should take you to http://slashdot.org/ Rob -----Original Message----- From: mark bannister [mailto:mark@injection-moldings.com] Sent: Saturday, September 06, 2003 9:07 AM To: suse-linux-e@suse.com Subject: [SLE] Newbie Linksys EG1032 1000 Mbps VERY new to Linux and SuSE. SuSE 8.2 i386 purchased Trying to install EG1032 network card. Card is identified as a NS82030 (I think that's right) and that driver is loaded (is that the right term?). There is an onboard NIC (eth0) as well that I have yet to get disabled (jumper on the board somewhere). It works fine. If I plug the network cable into the EG1032 it gets an IP address during boot but I cannot connect to the internet. I have read on other groups that the NS82030 driver works in SuSE (not sure of the build) but I'm not having any luck. Are there some standard settings I can try? And how would I make them and/or where would I find the info. Thanks Mark B -- Check the headers for your unsubscription address For additional commands send e-mail to suse-linux-e-help@suse.com Also check the archives at http://lists.suse.com Please read the FAQs: suse-linux-e-faq@suse.com
Ethernet cable is plugged into a switch. ADSL modem and router plugged into swith also. IP comes from DHCP on router. If I use the on-board NIC I can access the internet and network. Using the EG1032 I can't do either. Rob Sell wrote:
We need a little more info, are you using a router or are you plugging directly into a cable/dsl modem? You say you get an ip but cannot get anywhere on the internet, can you go to websites via ip addresses? Try this http://66.35.250.150/ that should take you to http://slashdot.org/
Rob
<snip>
participants (2)
-
mark bannister -
Rob Sell