Greetings all I have a problem re-setting up my routing tables. I had a hardware failure 2 weeks ago and had to re-install my SuSE version 6.3. Everything went back in that I wanted but I cannot get routing to work again. IP forwarding starts and the routing tables supposedly start, but routing just doesn't happen. Here is the setup. ISP Gateway IP is 10.10.129.254 Linux box with SuSE..eth0 ip is 10.10.129.6 Linux box eth1 is 192.168.0.1 connected through a 5 port hub to... WinBox 1 ip is 192.168.0.2 WinBox 2 ip is 192.168.0.3 Pinging from Linux box to either WinBoxes is good, and pinging from WinBoxes to eth1 is good. Linux box can surf the net, D'l mail etc. etc..Neither WinBox can ping eth0 or the ISP gateway (suffice to say they cannot get to the net..bad idea). Routing table on SuSE box: Destination Gateway Genmask Flags Metric Ref Use iface 192.168.0.1 10.10.129.6 255.255.255.255 UGH 0 0 0 eth0 10.10.129.6 10.10.129.254 255.255.255.255 UGH 0 0 0 eth0 10.10.129.0 10.10.129.254 255.255.255.0 UG 0 0 0 eth0 10.10.129.0 0.0.0.0 255.255.255.0 U 0 0 0 eth0 192.168.0.0 0.0.0.0 255.255.255.0 U 0 0 0 eth1 127.0.0.0 0.0.0.0 255.255.255.0 U 0 0 0 lo 127.0.0.0 0.0.0.0 255.0.0.0 U 0 0 0 lo 0.0.0.0 10.10.129.254 0.0.0.0 UG 0 0 0 eth0 My route.conf table: #Destination Dummy?Gateway Netmask Device # 127.0.0.0 0.0.0.0 255.255.255.0 lo 10.10.129.0 0.0.0.0 255.255.255.0 eth0 # #Gateway default 10.10.129.254 # #Host behind Gateway # 10.10.129.6 10.10.129.254 255.255.255.255 192.168.0.1 10.10.129.6 255.255.255.255 # # #Net behind gateway # 10.10.129.0 10.10.129.254 255.255.255.0 192.168.0.0 10.10.129.6 255.255.255.0 I hope that someone out there can straighten me out and can help me get my small network fully back on line. Thanks for any help. Doug Roberts dgr@sk.sympatico.ca ---------------------------------------------------------------------------- ------------- All right, who's been cooking hot dogs in the Warp Drive?
participants (1)
-
Doug Roberts