That setup is v. similar to mine - I have a 1.33 G Tbird also and a Thermosonic heatsink. The OC guys tend not to go for ThermalTakes because, although quiet and reasonably efficient, they're not the most effective coolers around. Even so you should not be getting temps as high as that unless you've overclocked it. I take it you're running a standard 1.33 Ghz set at 10x with a 133MHz bus. First advice is to forget about the front case fan and fit it to the rear instead. Front fans are often next to useless as they can just recirculate hot air over the board. Check the cooling guide on AMD's site for more information. Check you have an AMD approved PSU (ie not front-venting). Fitting the exhaust fan will help lower your system temp but to keep your core temp low you need to ensure you either have a decent thermal interface between the heatsink and the AMD core (like Arctic Silver II). I get an idle temp of 45C. I'm not sure what the full load temp is as I don't have a reliable way of finding out the temperatures in Linux. I've tried the sensors package but even after configuration that gives crazy temperatures like 50C for the system temps on idle (I know from the BIOS that it's around 35C). As a matter of interest, what ways are you (or others reading this) determining your temperatures? Tim Harrell
-----Original Message----- From: Guy Van Sanden [mailto:sienix@crosswinds.net] Sent: Monday, August 13, 2001 2:46 PM To: suse-linux-e@suse.com Subject: [SLE] AMD running too hot
Hello
I've been working on this for a long time now (and posted it previousely), but I can't seem to find any answers, other than that I'm not the only one with the problem...
I own an Athlon 1.333 Ghz an I'm running Linux. My CPU is running too warm, 56 °C and up... When I run something CPU-intensive, for a long time (like MP3 ripping), I can see the CPU temperature rise, and at about 60°C, my system automatically reboots :-(
So, I have this really beautiful machine here... but if I really try to use it, it goes down :-(
The frustrating part is that it's working fine with windows (I installed it to check thid problem)... It's running at 47°C idle, and gets to 58°C under highest stress.
Anyone got any clue what's causing this... It's like the CPU is ignoring the HLT instruction when idle...
SuSE Linux 7.2 running kernel 2.4.4 AMD AThlon 1.333 GHZ ThermalTake Volcano II cooler (running 5000 rpm) Extra cooler intake (front-bottom of my case @ 2500 rpm) Asus A7V133 Mb. 256 MB SDRAM
Help, It's making me desperate...
-- To unsubscribe send e-mail to suse-linux-e-unsubscribe@suse.com For additional commands send e-mail to suse-linux-e-help@suse.com Also check the FAQ at http://www.suse.com/support/faq and the archives at http://lists.suse.com
On Mon, Aug 13, 2001 at 01:28:44PM +0100, Harrell, Tim wrote: I am about to buy a PC with a 900Mhz AMD processor, it is being built for me..do I need to worry about temperature with this, I am going for a CPU cooler with it, do I need more than this ? Cliff
On Monday 13 August 2001 08:28 am, Harrell, Tim wrote: | That setup is v. similar to mine - I have a 1.33 G Tbird also and a | Thermosonic heatsink. The OC guys tend not to go for ThermalTakes | because, although quiet and reasonably efficient, they're not the | most effective coolers around. Even so you should not be getting | temps as high as that unless you've overclocked it. I take it | you're running a standard 1.33 Ghz set at 10x with a 133MHz bus. i'm running a 1.2-gig athlon and i have on the chip itself a cylindrical, two-fan, counter-rotating cooler with about four inches of heatsink fins, a slot fan, a front fan, the power supply fan of course, and an additional rear exhaust fan. chip runs quite cool. getting as much airflow as possible is the key, until tiny air-conditioners for chips are built. -- dep one day, you'll wish it was now. your wish has been granted. don't waste it.
On Mon, 13 Aug 2001 13:28:44 +0100 Lourens replied to Harrell,: [large snip] " but to keep your core temp low you need to ensure you either have a " decent thermal interface between the heatsink and the AMD core (like " Arctic Silver II). [end large snip] I have been experimenting with some CPU coolers and am a little concerned about the "thermal paste residual" around the core. I am certain that this hardens and minimizes the cooling efficiency of subsequent coolers.?!? Is there a safe / recommended way to remove this residual when swopping coolers?? TIA, Bye. *** Whatever you do will be insignificant, but it is very important that you do it. - Gandhi *** Powered by SuSE Linux 7.2 Professional Registered Linux User Lourens Steenkamp Republic of South Africa _________________________________________________________ Do You Yahoo!? Get your free @yahoo.com address at http://mail.yahoo.com
Lourens Steenkamp writes:
I have been experimenting with some CPU coolers and am a little concerned about the "thermal paste residual" around the core. I am certain that this hardens and minimizes the cooling efficiency of subsequent coolers.?!? Is there a safe / recommended way to remove this residual when swopping coolers??
Isopropyl alcohol, a good supply of cotton balls, and q-tips seems to work well for me. Argentium
On Tue, 14 Aug 2001 06:56:09 -0500 Lourens replied to Argentium: [snip] " >Is there a safe / recommended way to remove this residual when " swopping " >coolers?? " Isopropyl alcohol, a good supply of cotton balls, and q-tips seems to " work " well for me. [end snip] Thanks for the response *** If you find a solution and become attached to it, the solution may become your next problem. *** Powered by SuSE Linux 7.2 Professional Registered Linux User Lourens Steenkamp Republic of South Africa _________________________________________________________ Do You Yahoo!? Get your free @yahoo.com address at http://mail.yahoo.com
participants (5)
-
Argentium G. Tiger
-
Cliff Sarginson
-
dep
-
Harrell, Tim
-
Lourens Steenkamp