Rajko M. wrote:
On Sunday 18 February 2007 09:09, Peter Breger wrote:
but the router is correctly keeping all other PCs happy on the network, ... It is the boot process on the Linux that is at fault, being the only process which is not successful. Manual YaST setup succeeds. (Same as simultaneous use on other computers running windows does not show any problems at all).
Hi Peter,
Have you tried to setup static address for your connection? This will either solve your problem or make possible to cut and paste text direct from Linux box to continue DHCP troubleshooting :-)
You need some local address that is not used by router as DHCP range. By now all routers, that I have configured, don't use range between 192.168.x.201 and 192.168.x.254. The default route is your router 192.168.1.1 (I guess). The name server is the same as default route. Subnet Mask is usually 255.255.255.0
In YaST -- Network Devices -- Network Card use for this time Traditional Method with ifup. In Network Address Setup window mark: x Static Address Setup
IP Address
Subnet Mask 255.255.255.0 Click on Host and Name Server. It will pop up the window with warning, click on Modify. For now leave Hostname and Domain Name fields unchanged. Name Server 1 is <you-router IP> for instance 192.168.1.1 and you don't need any other entry on local network, router is taking care of that. Click OK.
Now you have to configure Routing that is hidden under the same name button. Enter in the field Default Gateway <you-router IP> ie. 192.168.1.1 Click OK. Click Next and Finish.
Thanks Rajko! I am afraid that did not do it either. In fact I had tried it before, but with your suggested IP range, I had another go at it. The assignment of IP address worked, however the Ping 192.168.1.1 then resulted in Destination Host unreachable. Had to first go through a full cycle with YaST : deleting card configuration ... then entering YaST again editing card configuration with static address --- voila it works while in the session -- BUT NOT AFTER REBOOT! So the behaviour is the same as with DHCP. It is possible to delete Network card configuration, then in a new YaST run edit it to connect successfully. But never on reboot (of course I use ON CABLE CONNECT in YasT for manual start of connection and ON BOOT for preparing a rebooting. Another snippet - after rebooting, the card has no IP address (previously set static 192.168.1.202). I then use ifconfig eth0 down. THEN type ifconfig eth0 192.168.1.202. THEN ifconfig eth0 up -- it works again. But not after reboot. What is it that is missing in the boot sequence??? Regards, Peter -- To unsubscribe, e-mail: opensuse+unsubscribe@opensuse.org For additional commands, e-mail: opensuse+help@opensuse.org