-----BEGIN PGP SIGNED MESSAGE----- Hash: SHA256 El 2017-12-12 a las 21:24 +0300, Andrei Borzenkov escribió:
11.12.2017 23:49, Paul Neuwirth пишет:
ok.. # echo "b" > /proc/sysrq-trigger worked
and no success... i mounted everything in the right paths, chrooted, fixed device.map and grub_installdevices ran yast bootloader
In the past it most definitely did not reinstall bootloader again. If you are sure you fixed grub_installdevice, run "update-bootloader --reinit".
YaST boot module writes everything if the boot timeout is changed :-)
error:
system up and running, btrfs raid assembled correctly. Thanks for any help.
but bootloader installation is not correct yet, any help appreciated.
Use /dev/disk/by-id to identify individual partitions. I am not sure what is high-level command to write generic bootloader (I think only YaST does it), so I usually change bootloader to NONE in YaST, exit bootloader module and then call bootloader module again and select grub2. In this case yast goes through normal sequence to initialize bootloader including all settings.
Try changing the timeout in just one second ;-) - -- Cheers Carlos E. R. (from openSUSE 42.2 x86_64 "Malachite" (Minas Tirith)) -----BEGIN PGP SIGNATURE----- Version: GnuPG v2 iF4EAREIAAYFAlowIBwACgkQja8UbcUWM1zjQgEAnfpb0R+qIcEbuMsbBzFT7C+E Fj0+bVLxMWmwvE8/QlMA/ipcMUlYmL5iPkZPxhiQMYU2b08cXrMgRVvHG3I5DtT4 =4q+U -----END PGP SIGNATURE-----