Hi, everyone. I'm running SuSE 9.1 Pro on a e-machine (T2842). Had been using the on-board chip for video. Just purchased a GeForce FX 5500PCI video card and I'm having problems. Hope that you can help. I uninstalled the driver for the onboard chip and then installed the new video card and rebooted. I then went into Yast2 (hardware) to load the driver. The closest one I could find was the GeForce FX 5200. Then I did a Yast2 on-line update to add the Nvidia driver. All of that seemed to go well. But I can't configure the video card. When I go into Yast2 (hardware) to try to set resolution, enable 3-D, etc. I click "change" but nothing happens. So I then went into the SuSE menu and clicked on system/configuration/SAX2, but SAX2 doesn't open. Again, the pooter just sits there and stares at me. So, what to do? What file should I be looking at to edit that will again let me configure the video card (run SAX2)? Also, by loading that FX5200 driver from Yast (since Yast did not present me with a choice of FX5500) have I created a problem? Thanks, gurus. Gil