Dne 17.9.2014 v 08:59 Per Jessen napsal(a):
josef Karliak wrote:
Hi, we've disabled ipv6 on all servers, we hadn't IPv6 IP from providers.
FYI, that's completely superfluous. I've checked again /etc/sysctl.conf : net.ipv6.conf.all.forwarding = 1 net.ipv6.conf.all.disable_ipv6 = 0
In this case the server is a firewall between LAN, DMZ and WAN. I enabled IPv6 on anothers server too, but only on this " important" server I've problem to enable IPv6. Why ? I am not familiar with how to disable/enable IPv6 at all, but I thought there was a kernel command line argument too? Depending on how you were disabling IPv6, maybe check your boot-config.
I've enabled all IPv6 by the Yast2 -> Lan -> "Enable IPv6" and rebooted. Except this firewall all was after reboot ready to set IPv6, huh ...
So, we have to run with IPv6 over older firewall (SLES11SP3) , it is fully functional... But as I said, it is old server, HP DL380G4. Thanks and best regards J.Karliak. -- To unsubscribe, e-mail: opensuse+unsubscribe@opensuse.org To contact the owner, e-mail: opensuse+owner@opensuse.org