where you normally would - use eth0 in yast or type in "ifconfig eth0 myi.paa.ddr.ess/24 up" or whatever subnet. On Thu, 16 Mar 2000, Robert Lyons wrote:
Do you mean the pcmcia package from the suse cd? and is that all I need to set up? After this is done and i put the card in the slot How or where do I go to configure parameters..IP address and netmask, etc.
Thanks Robert
On Thu, 16 Mar 2000, Tim Duggan wrote:
Hi,
-----Original Message----- From: Robert Lyons [SMTP:rlyons@faithdesign.com] Sent: Thursday, March 16, 2000 12:48 PM
Is it possible to load the pcmcia modules for a specific ethernet card after you have done the install of the system..If yes what is the proper procedure for doing this? I have a working system on my laptop and I want to addan ethernet card to it all...
If you have the pcmcia package set up, the new card should be autodetected by cardmgr which should load the proper module. To configure the interface check out the PCMCIA-Howto. If you have any problems let us know :-)
Tim
Thanks robert
-- To unsubscribe send e-mail to suse-linux-e-unsubscribe@suse.com For additional commands send e-mail to suse-linux-e-help@suse.com Also check the FAQ at http://www.suse.com/Support/Doku/FAQ/
-- ________________________________________________________________________________ If it isn't broken don't try to fix it. If it is, run away before anybody notices. ________________________________________________________________________________ This email brought to you by SuSE Linux and some friendly electrons. -- To unsubscribe send e-mail to suse-linux-e-unsubscribe@suse.com For additional commands send e-mail to suse-linux-e-help@suse.com Also check the FAQ at http://www.suse.com/Support/Doku/FAQ/