Hi list, I've got a D-Link DWL-G122 Rev C1 USB dongle that I'm trying to get working in SuSE 9.3 with ndiswrapper. So far I've installed ndiswrapper with yast, found some compatible winxp drivers and loaded them up. Now I'm a bit stuck though. I've tried using yast to add a new network device, both as USB and with the module specified as ndiswrapper but ifconfig never gives me any indication that it's made any difference. I get the following useful output: linux:/home/panda # ndiswrapper -l Installed ndis drivers: dr71wu driver present, hardware present linux:/home/panda # modprobe -v ndiswrapper insmod /lib/modules/2.6.11.4-21.11-default/extra/ndiswrapper.ko linux:/home/panda # ifconfig eth0 Link encap:Ethernet HWaddr 00:40:D0:2B:61:F4 inet addr:10.0.0.12 Bcast:255.255.255.255 Mask:255.0.0.0 inet6 addr: fe80::240:d0ff:fe2b:61f4/64 Scope:Link UP BROADCAST NOTRAILERS RUNNING MULTICAST MTU:1500 Metric:1 RX packets:413 errors:0 dropped:0 overruns:0 frame:0 TX packets:428 errors:0 dropped:0 overruns:0 carrier:0 collisions:0 txqueuelen:1000 RX bytes:237046 (231.4 Kb) TX bytes:84291 (82.3 Kb) Interrupt:11 Base address:0xe800 lo Link encap:Local Loopback inet addr:127.0.0.1 Mask:255.0.0.0 inet6 addr: ::1/128 Scope:Host UP LOOPBACK RUNNING MTU:16436 Metric:1 RX packets:226 errors:0 dropped:0 overruns:0 frame:0 TX packets:226 errors:0 dropped:0 overruns:0 carrier:0 collisions:0 txqueuelen:0 RX bytes:14329 (13.9 Kb) TX bytes:14329 (13.9 Kb) Any ideas where I'm going wrong? -- Paul