Hi, everyone. Was using 9.2. Just upgraded to 9.3 but problems. I formatted the drive and did a clean install. At the same time I added a video card (previously was using the on-board chip). The video card is a GeForce FX5500 PCI card ,128 MB memory, by PNY technologies (please note, that's PCI, not PCI-e). The MB does not have an AGP slot so I had to get a PCI video card. SuSE recognizes the card, but it absolutely will not let me configure it (set resolution or number of colors) and it will not let me set my monitor to the correct brand and model. If I go into Yast2modules/hardware/graphics card and monitor/<password> I am presented with 2 choices: text mode only graphical desktop environment. I tick the button next to graphical desktop envirnment and click "change" but nothing happens. The screen just sits and I am never taken to the screen for setting resolution or screen colors (or 3D acceleration if I were so inclined). In addition, that should be where I can choose my monitor settings. But no luck. "Reprobing" does no good after the screen flashes and comes back. So I then tried opening a shell as root, and I entered sax2. Here's the output I get: gil@phred:~> su Password: phred:/home/gil # sax2 SaX: initializing please wait... SaX: ups lost card during probing... abort phred:/home/gil # Again, I can't configure the video card or monitor. Any ideas? The video quality is not good. The picture is OK as long as it's still. But, for example, when I scroll up or down in Firefox or Konqueror the scrolling is horribly slow and jerky, and I get lines and lines of artifacts (ghosts of the text that is passing). After I move the scroll wheel many times all of a sudden the video seems to break loose and I'm suddenly at the bottom of the page. It's as if the video were under some terrible constraint while I turn the mouse wheel, and then suddenly it lets go. Many thanks, everyone, for your helpful suggestions. Gil