How about trying out one card at a time? First check if both cards are functioning by itself. Then config the both cards manually. That is using modprobe, ifconfig and route commands to troubleshoot. Please remember to turn off network configuration in YAST. "Gurunandan R. Bhat" wrote:
Greetings,
I rebuilt my kernel to compile in ne2k-pci support. I have two ethernet cards, both ne2k (They are SMC3200 actually). While both NICs are correctly detected during the initial bootup sequence, my machine freezes when it comes to initialising the second ethernet interface (eth1). I am using SuSE 6.3.
I went through the mail archives and the closest I could get was an incident where ne2k-pci cards failed on modprobe since 8329 modules were not included in the initrd dependency in 6.3.
I would greatly appreciate any help.
Thanks, Gurunandan
-- To unsubscribe send e-mail to suse-linux-e-unsubscribe@suse.com For additional commands send e-mail to suse-linux-e-help@suse.com Also check the FAQ at http://www.suse.com/Support/Doku/FAQ/
-- To unsubscribe send e-mail to suse-linux-e-unsubscribe@suse.com For additional commands send e-mail to suse-linux-e-help@suse.com Also check the FAQ at http://www.suse.com/Support/Doku/FAQ/