On Fri, 2004-10-08 at 12:25 -0400, Gil Weber wrote: --snip--
David, thx for reply. Unfortunately it did not help. Here's what happened when I followed your instructions....
1) After I logged in as root and entered
the next line came up reading: "initializing, please wait." 2) After a bit the screen flickered and went to a grey screen that looked like a very fine mesh (like on a screen door), with a large "X" in the center (the cursor).
3) Then that screen flickered and it went back to the screen where I logged in and entered your "sax" command. This time I got a message that read: "ups lost card during probing....abort."
4) And then that took me back to the original prompt where I tried it all over again, with the same results.
So something is screwed up.
I went into the "install and remove software" section of Yast2 and did a search for "SAX." I seem to have 3 items loaded:
a) sax2 b) saxident c) sax tools --snip--
Can you disable the on-board card via the bios? Perhaps that is what is confusing sax2. I have the same 3 packages installed for sax2 - have you run a complete online update, because these have been updated since the release of 9.1? David -- Registered Linux User No 207521 The Linux Counter: http://counter.li.org/ "The above is my personal opinion and does not necessarily reflect that of the little voices in my head."