Dne pondělí 13. dubna 2020 13:14:27 CEST, Andrei Borzenkov napsal(a):
13.04.2020 13:13, Vojtěch Zeisek пишет:
I'm going to set up aggregation of two network cards of single server to get better connectivity (load balancing,
It highly depends on your environment, workload and behavior of device on another side of link.
fault tolerance). I found SDB wiki article https://en.opensuse.org/SDB:Bonding which seems pretty outdated. Shouldn't it be rather deleted as there is appropriate section in <https://doc.opensuse.org/documentation/leap/reference/html/ book.opensuse.reference/cha-network.html#sec-network-iface-bonding> ? The settings seems pretty straightforward, should be fine, I hope. :-) Does anyone have experience with this?
Yes. Do you have some more concrete questions?
Documentation <https://doc.opensuse.org/documentation/leap/reference/html/ book.opensuse.reference/cha-network.html#sec-network-iface-bonding> shows on the print screen of YaST tab Bond Slaves, but when I edit the card (Network Card Setup), on the Address tab I can't change device type and I'm missing Bonding Slaves tab of the Network Settings module. The documentation starts with adding new device, but I see both network cards (eth0 with static IP and eth1 which should be bonded). Am I supposed to remove the eth1 device in YaST and add it again? Or how to proceed? Thank You, Your assumptions are wrong. You need to create a new device, YaST will show a
Op dinsdag 21 april 2020 19:00:12 CEST schreef Vojtěch Zeisek: list of options to pick from amongst which "Bonding". The rest is in the instructions. Mind, both current devices have to have an eth cable connected. -- Gertjan Lettink a.k.a. Knurpht openSUSE Forums Team -- To unsubscribe, e-mail: opensuse+unsubscribe@opensuse.org To contact the owner, e-mail: opensuse+owner@opensuse.org