Hi, I installed K3b on my 32 bit and 64 bit (TDE) computers and decided to test how the application performed. Settings > Configure K3b > Devices > Displays the following error: * Optical Devices In order to give K3b full access to the writer device the current user needs be added to a group cdrom. The Permission helper that could do this for you was not enabled during build. Please rebuild the package with the Permission helper enabled or contact your distribution. * K3b was able on both machines (32 and 64 bit TDE) to complete the burning of an .iso and verify without incident. I attached a screenshot of the error message here. > https://susepaste.org/26598876 1. How can I enable this permission helper that is spoke of? 2. How should I go about adding a cdrom group? I am not seeing the capability in (YaST > Control Center > Security and Users > User and Group Management >) most likely I am missing something about how to use this particular module. 3. Do I need to uninstall K3b and reinstall again (once a group cdrom is added)? 4. Will removing K3b and the dependencies of K3b through YaST Software Manager create potential dependency problems? 5. I was looking at this YaST CD-ROM Drives module page: > https://en.opensuse.org/YaST_CD-ROM_Drives Most likely I am missing something in the YaST - User and Group Management section. Is there a preferred openSUSE Wiki Portal on this topic of adding groups and users through YaST? I looked at this information briefly and it refers to a CD-ROM Drives module: > https://en.opensuse.org/YaST_CD-ROM_Drives < Seems to be not relevant most likely. What are your thoughts on this matter? -Regards