----- Original Message -----
From: "Ken Schneider"
On Mon, 2006-01-23 at 16:10 -0600, david rankin wrote:
From:
Guys, when I said it was a new box, I misspoke. It is new to my home, but it is the same box that worked flawlessly for the past 5 years at work as a server running mandrake 7.2. Nothing has changed and there is only one NIC. Yast only sees 1 NIC. Ifconfig shows: ifconfig will only show configured interfaces (ones with an active driver). Use dmesg to show all recognised hardware, even ones without a driver.
This is strange. What is the eth0 ADMtek from dmesg below? Linux Tulip driver version 1.1.13-NAPI (May 11, 2002) ACPI: PCI Interrupt Link [LNKB] enabled at IRQ 11 PCI: setting IRQ 11 as level-triggered ACPI: PCI Interrupt 0000:00:0f.0[A] -> Link [LNKB] -> GSI 11 (level, low) -> IRQ 11 tulip0: MII transceiver #1 config 1000 status 786d advertising 05e1. eth0: ADMtek Comet rev 17 at 0001ec00, 00:04:5A:87:C8:43, IRQ 11. NET: Registered protocol family 10 Disabled Privacy Extensions on device c036b920(lo) IPv6 over IPv4 tunneling driver ACPI: Power Button (FF) [PWRF] ACPI: Power Button (CM) [PWRB] ACPI: Sleep Button (CM) [SLPB] 0000:00:0f.0: tulip_stop_rxtx() failed eth1: Setting full-duplex based on MII#1 link partner capability of 45e1. -- David C. Rankin, J.D., P.E. RANKIN LAW FIRM, PLLC 510 Ochiltree Street Nacogdoches, Texas 75961 (936) 715-9333 (936) 715-9339 fax www.rankinlawfirm.com --