I have run Suse v6.4 and v7.3 successfully. Recently purchased v8.0 professional. Too replace win2k. I configured my network card with yast2 very simple ip address, subnet mask,DNS, Gateway, done. Trouble is it doesn't work. I do not have access to the rest of my network. Also no internet. I cannot ping any other box. I can successfully ping the linux box nic using its' ip address and loopback also works. I reinstalled win2k and I have access to everything on my network and the internet. I reinstalled Linux with the default setting, sans office and firewall, same problem. I also get a message in the console log that module c cannot be found. I get this error with three different installations. I haven't a clue what module c is and can find no referenjce to it any where. If anyone has a clue as to what is wrong please help. My config information is: Ifconfig eth0 Link encap:Ethernet HWaddr 00:A0:C9:ED:56:29 inet addr:192.168.0.9 Bcast:192.168.0.255 Mask:255.255.255.0 inet6 addr: fe80::2a0:c9ff:feed:5629/10 Scope:Link UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1 RX packets:0 errors:0 dropped:0 overruns:0 frame:0 TX packets:0 errors:1 dropped:0 overruns:0 carrier:1 collisions:0 txqueuelen:100 RX bytes:0 (0 Kb) TX bytes:1764 (1.7 Kb) Interrupt:5 Base address:0x1060 Memory:fa126000-fa126038 lo Link encap:Local Loopback inet addr:127.0.0.1 Mask:255.0.0.0 inet6 addr: ::1/128 Scope:Host UP LOOPBACK RUNNING MTU:16436 Metric:1 RX packets:34 errors:0 dropped:0 overruns:0 frame:0 TX packets:34 errors:0 dropped:0 overruns:0 carrier:0 collisions:0 txqueuelen:0 RX bytes:2308 (2.2 Kb) TX bytes:2308 (2.2 Kb) Kernel IP routing table Destination Gateway Genmask Flags Metric Ref Use Iface 192.168.0.0 0.0.0.0 255.255.255.0 U 0 0 0 eth0 0.0.0.0 192.168.0.1 0.0.0.0 UG 0 0 0 eth0 netstat -tn Proto Recv-Q Send-Q Local Address Foriegn Address State