Hi folks!
Sorry for the late reply but bravia seems a bit beastly.
I took the xorg.conf as providd by Luc but the monitor could still not be detected (log says vsync
out of range). I then tuned the vsync and hsync as long as the log tells me that 1280x768 is
covered, but radeonhd still took the detected 1360x768 (which cuts off the left border of my X).
With HDMI i obviously got no result at all.
I also tested the system with the latest fglrx and got the following results:
I was able to connect via VGA with up to 1024x768 but not higher (not even 1280x768!).
With HDMI attached, I only could setup 720p (1280x720 which lefts out a large spare black border).
txs,
strub
--- Markus Keil
Am Montag, den 19.11.2007, 20:19 +0100 schrieb Luc Verhaegen:
On Sat, Oct 27, 2007 at 07:49:41PM +0200, Mark Struberg wrote:
Hi!
2.) On a Sony Bravia 720p Panel (native resolution 1366 x 768) it basically works but cuts off a few pixels left and right (i guess its cutted down to 1280, xorg.log attached).
The monitor only reports 1280x768.
Let me provide you with some especially tailored xorg.conf stuff to work around this.
Add the following monitor section:
Section "Monitor" Identifier "bravia" HorizSync 30-50 VertRefresh 58-62 Option "ReducedBlanking" "True" Option "NoDDC" "True" EndSection
Add the following line to the "Device" section for the radeonhd driver:
Option "UseConfiguredMonitor" "True"
In the Screen section, reference your monitor:
Monitor "bravia"
Provide only the following mode in the "Display" subsection for your bitdepth:
Modes "1366x768R"
This will hopefully have the driver: * Ignore ddc and use only the configured monitor. * Autogenerate an exact 1366x768 mode (not 1360 or 1368) with reduced blanking. (There is no other driver out there which will do this btw). * And this mode should survive all modevalidation thanks to the provided monitor timing.
If your monitor allows this mode through its VGA input, then this will work.
Luc Verhaegen. SUSE/Novell X Driver Developer and Modesetting wizard.
Hi!
I've the same setup here. Pundit with RS690 and a Sony Bravia Panel. Due the manual of the Bravia the highest resolution using the VGA-Input is 1280x768. to get the full resolution of 1366x768 you have to connect your pundit with an HDMI-cable, but i don't know if the radeonhd supports the output through the hdmi-connector.
Markus Keil
__________________________________ Ihr erstes Baby? Holen Sie sich Tipps von anderen Eltern. www.yahoo.de/clever -- To unsubscribe, e-mail: radeonhd+unsubscribe@opensuse.org For additional commands, e-mail: radeonhd+help@opensuse.org