http://bugzilla.opensuse.org/show_bug.cgi?id=1171807 http://bugzilla.opensuse.org/show_bug.cgi?id=1171807#c9 --- Comment #9 from Reg Proctor <novell@regproctor.com> --- Sorry, I didn't see your question for a while. I had a couple of computers fail on me and at the same time I had our main and backup air conditioning fail (I'm in AZ, it matters) and I was down for quite some time (almost a month!). I upgraded to 15.2 and it seems far more stable but I did end up doing a fresh install because I had a boot problem (yep, this was on the machines that was down when the AC went down) which I couldn't get past any other way. I did encounter a couple of crashes in 15.2 but that might have been openGL and I have since set my rendering to renderx so with a little luck the problem might be solved. The other possibility to the openGL hypothesis is that the crashing seemed to increase after I ran `sensor-detect` which I needed to do for it to pick up, as sensor-detect describes the chip, "Nuvoton NCT6791D Super IO Sensors". Once it's been run I can then get all the sensors from that chip and I monitor many of the fan speeds & temperatures in kSysGuard so that could be thing. If you want we could close this and I'll reopen it only if it seems to still be there, I figure a month of use from now should be enough to tell for sure if the problem is still there. -- You are receiving this mail because: You are the assignee for the bug.