Comment # 9 on bug 1171807 from Reg Proctor

Sorry, I didn't see your question for a while. I had a couple of computers fail
on me and at the same time I had our main and backup air conditioning fail (I'm
in AZ, it matters) and I was down for quite some time (almost a month!).

I upgraded to 15.2 and it seems far more stable but I did end up doing a fresh
install because I had a boot problem (yep, this was on the machines that was
down when the AC went down) which I couldn't get past any other way. I did
encounter a couple of crashes in 15.2 but that might have been openGL and I
have since set my rendering to renderx so with a little luck the problem might
be solved.

The other possibility to the openGL hypothesis is that the crashing seemed to
increase after I ran `sensor-detect` which I needed to do for it to pick up, as
sensor-detect describes the chip, "Nuvoton NCT6791D Super IO Sensors". Once
it's been run I can then get all the sensors from that chip and I monitor many
of the fan speeds & temperatures in kSysGuard so that could be thing.

If you want we could close this and I'll reopen it only if it seems to still be
there, I figure a month of use from now should be enough to tell for sure if
the problem is still there.