Hello all I installed Windows 10 on a friend's PC which has a 500 GB hard drive as well as a small SanDisk-SSD i100 24 GG flash drive. I pre formatted both drives NTFS before the install. The fresh install of Win 10 ignored the existing SanDisk-SSD i100*. This seems like a bit of a waste. Yast2 reads the SanDisk-SSD i100 size as 22.37 Gio. [*] Seen as /dev/sdb 22.37 Gio HPFS/NFDS NTFS under Yast2 on Leap42.2 I would like to install Leap42.2 on this machine using an EXT4 filesystem. Note : I usually do something simple like this Filesystem Size Used Avail Use% Mounted on /dev/sda1 43G 27G 14G 67% / Any advice in terms of the size to use to setup (via the Export mode using Yast2) the different (home, var partitions) filesystems (for a low maintenance setup) so that Leap42.2 can take advantage of the small and used SanDisk-SSD i100 24 GB flash drive would be greatly appreciated. Many thanks in advance Regards James -- To unsubscribe, e-mail: opensuse-factory+unsubscribe@opensuse.org To contact the owner, e-mail: opensuse-factory+owner@opensuse.org