https://bugzilla.suse.com/show_bug.cgi?id=1213609 https://bugzilla.suse.com/show_bug.cgi?id=1213609#c2 --- Comment #2 from Maxime Thirion <maxime.thirion@r-virtuel.net> --- I have the same problem. For example, I want to add the SSH service in the "home" zone. The window closes immediately. When I open Yast2 firewall again, the service doesn't appear in the list of authorized services. However, the change has been made and is visible via firewall-cmd --list-all-zones. I encounter the same problem with cli and gui. No output is generated. Tumbleweed 20230729. -- You are receiving this mail because: You are on the CC list for the bug.

https://bugzilla.suse.com/show_bug.cgi?id=1213609 https://bugzilla.suse.com/show_bug.cgi?id=1213609#c4 --- Comment #4 from Christian Tallner <christian.tallner@gmx.de> --- (In reply to Knut Alejandro Anderssen González from comment #1)

(In reply to Christian Tallner from comment #0)

...

User-Agent: Mozilla/5.0 (X11; Linux x86_64) AppleWebKit/537.36 (KHTML, like Gecko) Chrome/114.0.0.0 Safari/537.36 Build Identifier:

I added TCP Port rules to my home zone in the Yast2 Firewall Configuration. After closing and opening the Firewall Configuration the Port is not visible.

when executing "sudo firewall-cmd --list-all-zones" the configured port 8080 is listed though:

home (active) target: default ingress-priority: 0 egress-priority: 0 icmp-block-inversion: no interfaces: wlo1 sources: services: dhcpv6-client kdeconnect mdns samba-client ssh ports: 8080/tcp protocols: forward: yes masquerade: no forward-ports: source-ports: icmp-blocks: rich rules:

Reproducible: Always

Steps to Reproduce: 1.Add a new Port rule for a zone in the Yast2 Firewall Configuration 2.Close the Firewall Configuration and restart Yast2 3.Open the Firewall Configuration and inspect the Ports tab of the zone. Actual Results: No Ports are displayed in the ports tab.

Expected Results: The added Port should be displayed in the ports tab.

It is only possible for me to remove the configured port by using firewall-cmd, You can not do so from the GUI, because it is not displayed.

Would be nice to have logs as described here https://en.opensuse.org/openSUSE:Report_a_YaST_bug.

Which service action was done when applied the configuration, just a reloard or a restart of the service? The port is shown when running sudo firewall-cmd --permanent --list-all-zones

sudo firewall-cmd --permanent --list-all-zones Does not list the port. sudo firewall-cmd --list-all-zones Does list the port. I added the logs, sorry for the delay. -- You are receiving this mail because: You are on the CC list for the bug.