Comment # 4 on bug 1213609 from Christian Tallner

(In reply to Knut Alejandro Anderssen González from comment #1)
> (In reply to Christian Tallner from comment #0)
> > User-Agent:       Mozilla/5.0 (X11; Linux x86_64) AppleWebKit/537.36 (KHTML,
> > like Gecko) Chrome/114.0.0.0 Safari/537.36
> > Build Identifier: 
> > 
> > I added TCP Port rules to my home zone in the Yast2 Firewall Configuration.
> > After closing and opening the Firewall Configuration the Port is not visible.
> > 
> > when executing "sudo firewall-cmd --list-all-zones"
> > the configured port 8080 is listed though:
> > 
> > home (active)
> >   target: default
> >   ingress-priority: 0
> >   egress-priority: 0
> >   icmp-block-inversion: no
> >   interfaces: wlo1
> >   sources: 
> >   services: dhcpv6-client kdeconnect mdns samba-client ssh
> >   ports: 8080/tcp
> >   protocols: 
> >   forward: yes
> >   masquerade: no
> >   forward-ports: 
> >   source-ports: 
> >   icmp-blocks: 
> >   rich rules: 
> > 
> > 
> > 
> > Reproducible: Always
> > 
> > Steps to Reproduce:
> > 1.Add a new Port rule for a zone in the Yast2 Firewall Configuration
> > 2.Close the Firewall Configuration and restart Yast2
> > 3.Open the Firewall Configuration and inspect the Ports tab of the zone.
> > Actual Results:  
> > No Ports are displayed in the ports tab.
> > 
> > Expected Results:  
> > The added Port should be displayed in the ports tab.
> > 
> > It is only possible for me to remove the configured port by using
> > firewall-cmd, You can not do so from the GUI, because it is not displayed.
> 
> Would be nice to have logs as described here
> https://en.opensuse.org/openSUSE:Report_a_YaST_bug.
> 
> Which service action was done when applied the configuration, just a reloard
> or a restart of the service? The port is shown when running sudo
> firewall-cmd --permanent --list-all-zones

sudo firewall-cmd --permanent --list-all-zones 
Does not list the port.
sudo firewall-cmd --list-all-zones 
Does list the port.
I added the logs, sorry for the delay.