http://bugzilla.suse.com/show_bug.cgi?id=1127766 http://bugzilla.suse.com/show_bug.cgi?id=1127766#c8 --- Comment #8 from Arvin Schnell <aschnell@suse.com> --- (In reply to Ancor Gonzalez Sosa from comment #4)
Since the exit code of that command is zero, the installer concludes Snapper is configured and a snapshot can/must be performed.
Which normally is fine. But the 'list-configs' command does not verify that the configs are actually sound/available. Here that is not the case. (In reply to Olaf Hering from comment #7)
I'm sure I never used snapper, perhaps a config as included in earlier pkgs?
The config file is not included in an RPM. Likely it was generated during installation by YaST (using snapper). -- You are receiving this mail because: You are on the CC list for the bug.