Comment # 8 on bug 1127766 from Arvin Schnell

(In reply to Ancor Gonzalez Sosa from comment #4)

> Since the exit code of that command is zero, the installer concludes Snapper
> is configured and a snapshot can/must be performed.

Which normally is fine. But the 'list-configs' command does not verify
that the configs are actually sound/available. Here that is not the
case.

(In reply to Olaf Hering from comment #7)

> I'm sure I never used snapper, perhaps a config as included in earlier pkgs?

The config file is not included in an RPM. Likely it was generated during
installation by YaST (using snapper).