https://bugzilla.novell.com/show_bug.cgi?id=310305#c57
--- Comment #57 from Dean Hilkewich 2007-09-23 14:02:34 MST ---
Created an attachment (id=174081)
--> (https://bugzilla.novell.com/attachment.cgi?id=174081)
Initial Xorg.conf after completing Stage 2 of install.
Andreas, the initial login issue seems to have resolved itself when updates to
the NTP service is disabled AND the filesystem is XFS. Switching to EXT3 and
disabling the NTP service resolves that issue which I believe has already been
cured in recent patches. Once that was sorted out (by formatting to EXT3 and
disabling NTP) I was able to successfully complete the second stage of install,
but alas Sax still does not work right. After the initial xorg.conf is written
in stage 2, xorg does boot up but timing issues with multisyc CRT's still are
there (scrambled video out upon first boot to desktop) and Sax still refuses to
give a complete resolution settings. I no longer think this is a result of
evdev but is a bug that just appeared after the evdev bug was cured with
patching (although the left and right are reversed on tilt wheel with evdev).
The sax2 generated xorg (attachment xorg.conf.initialstage2) results in a
scrambled screen because of timings.
Then when a reboot to init 3 is done and a sax2 -r is done it gives a xorg.conf
file that is completely wrong in metamodes and subsequent runnings of sax2
changes no enteries nor writes a new xorg.conf file. (attachment
xorg.conf.sax)
A handmade xorg.conf will work fine (attachment xorg.conf.works) but even that
does not allow sax to recreate a new xorg.conf when ran and still does not
allow proper resolution selection in sax2.
--
Configure bugmail: https://bugzilla.novell.com/userprefs.cgi?tab=email
------- You are receiving this mail because: -------
You are on the CC list for the bug.