http://bugzilla.suse.com/show_bug.cgi?id=1138874
http://bugzilla.suse.com/show_bug.cgi?id=1138874#c6
--- Comment #6 from Michal Suchanek ---
We don't have tags for openSUSE so here are the git commits:
Release : lp151.28.4.1
GIT Revision: af35fd11466ddb32ce5df4bc094d71af8b3b86aa
GIT Branch: openSUSE-15.1
Release : lp151.28.7.1
GIT Revision: f8a1872c2e97826e8e0333012932aa99b5041ddd
GIT Branch: openSUSE-15.1
And these are qla patches added/removed:
+
patches.drivers/scsi-qla2xxx-Fix-panic-from-use-after-free-in-qla2x0.patch
+
patches.drivers/scsi-qla2xxx-Add-protection-mask-module-parameters.patch
+
patches.drivers/scsi-qla2xxx-Fix-DMA-error-when-the-DIF-sg-buffer-cr.patch
+
patches.drivers/scsi-qla2xxx-no-need-to-check-return-value-of-debugf.patch
+
patches.drivers/scsi-qla2xxx-Move-debug-messages-before-sending-srb-.patch
+
patches.drivers/scsi-qla2xxx-remove-redundant-null-check-on-pointer-.patch
+
patches.drivers/scsi-qla2xxx-Fix-LUN-discovery-if-loop-id-is-not-ass.patch
+
patches.drivers/scsi-qla2xxx-Add-First-Burst-support-for-FC-NVMe-dev.patch
+
patches.drivers/scsi-qla2xxx-Fix-unload-when-NVMe-devices-are-config.patch
+
patches.drivers/scsi-qla2xxx-Check-for-FW-started-flag-before-aborti.patch
+
patches.drivers/scsi-qla2xxx-Prevent-multiple-ADISC-commands-per-ses.patch
+ patches.drivers/scsi-qla2xxx-Add-support-for-setting-port-speed.patch
+
patches.drivers/scsi-qla2xxx-Prevent-SysFS-access-when-chip-is-down.patch
+ patches.drivers/scsi-qla2xxx-Move-marker-request-behind-QPair.patch
+
patches.drivers/scsi-qla2xxx-Fix-code-indentation-for-qla27xx_fwdt_e.patch
+ patches.drivers/scsi-qla2xxx-Add-new-FW-dump-template-entry-types.patch
+
patches.drivers/scsi-qla2xxx-Update-driver-version-to-10.00.00.14-k.patch
+
patches.drivers/scsi-qla2xxx-Avoid-PCI-IRQ-affinity-mapping-when-mul.patch
+ patches.drivers/scsi-qla2xxx-avoid-printf-format-warning.patch
+ patches.drivers/scsi-qla2xxx-check-for-kstrtol-failure.patch
+ patches.drivers/scsi-qla2xxx-Add-fw_attr-and-port_no-SysFS-node.patch
+ patches.drivers/scsi-qla2xxx-Remove-FW-default-template.patch
+ patches.drivers/scsi-qla2xxx-Fix-routine-qla27xx_dump_-mpi-ram.patch
+ patches.drivers/scsi-qla2xxx-Add-Device-ID-for-ISP28XX.patch
+ patches.drivers/scsi-qla2xxx-Add-Serdes-support-for-ISP28XX.patch
+
patches.drivers/scsi-qla2xxx-Correctly-report-max-min-supported-spee.patch
+
patches.drivers/scsi-qla2xxx-Cleanups-for-NVRAM-Flash-read-write-pat.patch
+
patches.drivers/scsi-qla2xxx-Add-support-for-multiple-fwdump-templat.patch
+ patches.drivers/scsi-qla2xxx-Update-flash-read-write-routine.patch
+
patches.drivers/scsi-qla2xxx-Correction-and-improvement-to-fwdt-proc.patch
+
patches.drivers/scsi-qla2xxx-Simplification-of-register-address-used.patch
+
patches.drivers/scsi-qla2xxx-Add-28xx-flash-primary-secondary-status.patch
+
patches.drivers/scsi-qla2xxx-Secure-flash-update-support-for-ISP28XX.patch
+
patches.drivers/scsi-qla2xxx-Update-driver-version-to-10.01.00.15-k.patch
+ patches.drivers/scsi-qla2xxx-Simplify-conditional-check-again.patch
+ patches.drivers/scsi-qla2xxx-Set-remote-port-devloss-timeout-to-0.patch
+
patches.drivers/scsi-qla2xxx-Fix-read-offset-in-qla24xx_load_risc_fl.patch
- patches.suse/qla2xxx-allow-irqbalance-control-in-non-MQ-mode.patch
+ patches.kabi/qla2xxx-kABI-fixes-for-v10.00.00.14-k.patch
+ patches.kabi/qla2xxx-kABI-fixes-for-v10.01.00.15-k.patch
This is openSUSE so you are free to build lp151.28.7 with the patches reverted
and bisect them to determine which one breaks your setup.
--
You are receiving this mail because:
You are on the CC list for the bug.