https://bugzilla.novell.com/show_bug.cgi?id=656642
https://bugzilla.novell.com/show_bug.cgi?id=656642#c4
--- Comment #4 from Harri Miettinen 2010-12-01 18:33:07 UTC ---
Yes it works on milestone 2.
I have used /usr/sbin/install_bcm43xx_firmware to install the driver.
This is the hwinfo from milestone 2 version
hwinfo --wlan
25: PCI 600.0: 0282 WLAN controller
[Created at pci.318]
Unique ID: y9sn.YXxFBNiV6c8
Parent ID: WL76.MLkyAiVHgf0
SysFS ID: /devices/pci0000:00/0000:00:09.0/0000:06:00.0
SysFS BusID: 0000:06:00.0
Hardware Class: network
Model: "Broadcom BCM4312 802.11b/g"
Vendor: pci 0x14e4 "Broadcom"
Device: pci 0x4315 "BCM4312 802.11b/g"
SubVendor: pci 0x103c "Hewlett-Packard Company"
SubDevice: pci 0x1508
Revision: 0x01
Driver: "b43-pci-bridge"
Driver Modules: "ssb"
Device File: wlan0
Features: WLAN
Memory Range: 0x92000000-0x92003fff (rw,non-prefetchable)
IRQ: 17 (no events)
HW Address: 90:4c:e5:6e:d4:c5
Link detected: yes
WLAN channels: 1 2 3 4 5 6 7 8 9 10 11 12 13 14
WLAN frequencies: 2.412 2.417 2.422 2.427 2.432 2.437 2.442 2.447 2.452 2.457
2.462 2.467 2.472 2.484
WLAN encryption modes: WEP40 WEP104 TKIP CCMP
WLAN authentication modes: open sharedkey wpa-psk wpa-eap
Module Alias: "pci:v000014E4d00004315sv0000103Csd00001508bc02sc80i00"
Driver Info #0:
Driver Status: ssb is active
Driver Activation Cmd: "modprobe ssb"
Config Status: cfg=no, avail=yes, need=no, active=unknown
Attached to: #5 (PCI bridge)
--
Configure bugmail: https://bugzilla.novell.com/userprefs.cgi?tab=email
------- You are receiving this mail because: -------
You are on the CC list for the bug.