From: Rudloff <thomas_rudloff(a)gmx.net>
Sent: 22 May 2021 02:44
Subject: RE: openSUSE-Tumbleweed-ARM-JeOS-rockpro64.aarch64-2021.05.17-
Build5.5 does not finish booting
I tested it again. Same result. But the rockpi4 image boots my rockpro64. But on
That's unexpected that image for rockpi4 boots on the rockpro64 board, but image for
rockpro64 does not boot properly on the rockpro64 board...
both boards there is no video output. Now I found that
there is a rockpro64v2
DTB and my board is a V2.
The only diff between V1 and V2 seems to be the audio codec setup. So, I suspect this does
not prevent the board to boot.
And there seems to be a better DTB for the V1.4 rockpi.
Where is the setting which DTB to use. Is there a chart where the things are
stored? It is anoying searching the information if one does not know what to
You can update the DTB file that u-boot loads, by interrupting the auto-boot and setting
the DTB file in u-boot. (you likely need a serial for that).
IMPORTANT NOTICE: The contents of this email and any attachments are confidential and may
also be privileged. If you are not the intended recipient, please notify the sender
immediately and do not disclose the contents to any other person, use it for any purpose,
or store or copy the information in any medium. Thank you.