Hi all, After a couple of "zypper dup's ago, I noticed that direct after the default option in grub, the screen went black after the subsequent loading. Until last week, I could continue by selecting in grub an older kernel (6.0.3 afaicr) Now however, the default image, but 6.0.7-1 and 6.0.8-1 yield the same results: It boots and loads initrd, but screen turns black, and no desktop appears any more, even after waiting for hours. According to the leds of the rpi (and the heat-sink) it is up-and running. CTRL-ALT-F1...12 doesn't do anything, neither ctr-alt-backspace Any suggestions would be welcomed Met vriendelijke groet, Hans Witvliet, J, Ing., DMO/OPS/I&S/APH, Kennis Team Opensource Coldenhovelaan 1 Maasland 3531RC Coldehovelaan 1, kamer B213 Dit bericht kan informatie bevatten die niet voor u is bestemd. Indien u niet de geadresseerde bent of dit bericht abusievelijk aan u is toegezonden, wordt u verzocht dat aan de afzender te melden en het bericht te verwijderen. De Staat aanvaardt geen aansprakelijkheid voor schade, van welke aard ook, die verband houdt met risico's verbonden aan het elektronisch verzenden van berichten. This message may contain information that is not intended for you. If you are not the addressee or if this message was sent to you by mistake, you are requested to inform the sender and delete the message. The State accepts no liability for damage of any kind resulting from the risks inherent in the electronic transmission of messages.