Andi Kleen wrote:
On Sat, Apr 23, 2005 at 12:15:01AM -0400, Mark Horton wrote:
I just received 9.3 today and installed it on my workstation. I had to add 'mem=2000m' to the kernel boot options get it to boot up after the install. Is this a known problem?
No. Can you post a serial console log of a bootup without the option?
-Andi
I got a serial cable hooked up and the output is below. Mark Bootdata ok (command line is root=/dev/hda4 vga=0x317 selinux=0 console=tty0 desktop elevator=as splash=verbose console=tty0 console=ttyS0,115200) Linux version 2.6.11.4-20a-smp (geeko@buildhost) (gcc version 3.3.5 20050117 (prerelease) (SUSE Linux)) #1 SMP Wed Mar 23 21:52:37 UTC 2005 BIOS-provided physical RAM map: BIOS-e820: 0000000000000000 - 000000000009fc00 (usable) BIOS-e820: 000000000009fc00 - 00000000000a0000 (reserved) BIOS-e820: 00000000000e0000 - 0000000000100000 (reserved) BIOS-e820: 0000000000100000 - 00000000bfff0000 (usable) BIOS-e820: 00000000bfff0000 - 00000000bffff000 (ACPI data) BIOS-e820: 00000000bffff000 - 00000000c0000000 (ACPI NVS) BIOS-e820: 00000000ff780000 - 0000000100000000 (reserved) BIOS-e820: 0000000100000000 - 0000000240000000 (usable) SRAT: PXM 0 -> APIC 0 -> Node 0 SRAT: PXM 1 -> APIC 1 -> Node 1 SRAT: Node 0 PXM 0 100000-bfffffff SRAT: Node 1 PXM 1 140000000-23fffffff SRAT: Node 0 PXM 0 0-bfffffff node 1 shift 24 addr 140000000 conflict 0 node 1 shift 25 addr 1fe000000 conflict 0 Bootmem setup node 0 0000000000000000-00000000bfffffff Bootmem setup node 1 0000000140000000-000000023fffffff ACPI: LAPIC (acpi_id[0x01] lapic_id[0x00] enabled) Processor #0 15:5 APIC version 16 ACPI: LAPIC (acpi_id[0x02] lapic_id[0x01] enabled) Processor #1 15:5 APIC version 16 ACPI: LAPIC (acpi_id[0x03] lapic_id[0x82] disabled) ACPI: LAPIC (acpi_id[0x04] lapic_id[0x83] disabled) ACPI: IOAPIC (id[0x02] address[0xfec00000] gsi_base[0]) IOAPIC[0]: apic_id 2, version 17, address 0xfec00000, GSI 0-23 ACPI: IOAPIC (id[0x03] address[0xfa9fe000] gsi_base[24]) IOAPIC[1]: apic_id 3, version 17, address 0xfa9fe000, GSI 24-27 ACPI: IOAPIC (id[0x04] address[0xfa9ff000] gsi_base[28]) IOAPIC[2]: apic_id 4, version 17, address 0xfa9ff000, GSI 28-31 ACPI: INT_SRC_OVR (bus 0 bus_irq 0 global_irq 2 dfl dfl) ACPI: INT_SRC_OVR (bus 0 bus_irq 0 global_irq 2 dfl dfl) Setting APIC routing to flat ACPI: HPET id: 0x102282a0 base: 0xfec01000 Using ACPI (MADT) for SMP configuration information Checking aperture... CPU 0: aperture @ f0000000 size 128 MB CPU 1: aperture @ f0000000 size 128 MB Built 2 zonelists Kernel command line: root=/dev/hda4 vga=0x317 selinux=0 console=tty0 desktop elevator=as splash=verbose console=tty0 console=ttyS0,115200 bootsplash: verbose mode. Initializing CPU#0 PID hash table entries: 4096 (order: 12, 131072 bytes) time.c: Using 14.318180 MHz HPET timer. time.c: Detected 2193.023 MHz processor. Console: colour dummy device 80x25 Dentry cache hash table entries: 1048576 (order: 11, 8388608 bytes) Inode-cache hash table entries: 524288 (order: 10, 4194304 bytes) Memory: 7219276k/9437184k available (2280k kernel code, 0k reserved, 1179k data, 212k init) Security Framework v1.0.0 initialized SELinux: Disabled at boot. Mount-cache hash table entries: 256 (order: 0, 4096 bytes) CPU: L1 I Cache: 64K (64 bytes/line), D cache 64K (64 bytes/line) CPU: L2 Cache: 1024K (64 bytes/line) CPU 0(1) -> Node 0 checking if image is initramfs... it is ACPI: Looking for DSDT in initrd... not found! not found! Using local APIC NMI watchdog using perfctr0 CPU: L1 I Cache: 64K (64 bytes/line), D cache 64K (64 bytes/line) CPU: L2 Cache: 1024K (64 bytes/line) CPU 0(1) -> Node 0 CPU0: AMD Opteron(tm) Processor 248 stepping 08 per-CPU timeslice cutoff: 1023.71 usecs. task migration cache decay timeout: 2 msecs. Booting processor 1/1 rip 6000 rsp ffff810144537f58 Initializing CPU#1 CPU: L1 I Cache: 64K (64 bytes/line), D cache 64K (64 bytes/line) CPU: L2 Cache: 1024K (64 bytes/line) CPU 1(1) -> Node 1 AMD Opteron(tm) Processor 248 stepping 08 Total of 2 processors activated (8699.90 BogoMIPS). Using local APIC timer interrupts. Detected 12.460 MHz APIC timer. checking TSC synchronization across 2 CPUs: passed. time.c: Using HPET based timekeeping. Brought up 2 CPUs NET: Registered protocol family 16 PCI: Using configuration type 1 mtrr: v2.0 (20020519) ACPI: Subsystem revision 20050211 ACPI: Interpreter enabled ACPI: Using IOAPIC for interrupt routing ACPI: PCI Root Bridge [PCI0] (00:00) PCI: Probing PCI hardware (bus 00) Unable to handle kernel paging request at 0000000000002730 RIP: <ffffffff80120ed3>{iounmap+323} PGD 0 Oops: 0000 [1] SMP CPU 1 Modules linked in: Pid: 1, comm: swapper Not tainted 2.6.11.4-20a-smp RIP: 0010:[<ffffffff80120ed3>] <ffffffff80120ed3>{iounmap+323} RSP: 0018:ffff810144471be8 EFLAGS: 00010293 RAX: ffff8100fa8fd000 RBX: ffff810144541bc0 RCX: 000000000000001a RDX: ffffffff7fffffff RSI: 0000000000002000 RDI: 00000000fa8fd000 RBP: ffffc20000004000 R08: 0000000000000000 R09: 0000000000000000 R10: 0000000000000000 R11: ffffffff80470ff8 R12: ffffffff803d8670 R13: ffff81014451da00 R14: ffff810144550800 R15: ffff81014451de00 FS: 0000000000000000(0000) GS:ffffffff804e3300(0000) knlGS:0000000000000000 CS: 0010 DS: 0018 ES: 0018 CR0: 000000008005003b CR2: 0000000000002730 CR3: 00000000bfe80000 CR4: 00000000000006e0 Process swapper (pid: 1, threadinfo ffff810144470000, task ffff8100bffc3750) Stack: ffffffff803d8670 ffffc20000004000 00000000000001ea ffffffff8022dc77 0000000000000000 0000000000000000 ffff81014451da00 ffffffff803d82a0 ffff810144550800 ffffffff803d8670 Call Trace:<ffffffff8022dc77>{quirk_usb_early_handoff+871} <ffffffff8022d008>{pci_fixup_device+136} <ffffffff8022b53c>{pci_scan_single_device+1084} <ffffffff8022b59e>{pci_scan_slot+30} <ffffffff8022bc0f>{pci_scan_child_bus+31} <ffffffff8022baa6>{pci_scan_bridge+390} <ffffffff8022bc5b>{pci_scan_child_bus+107} <ffffffff8022be09>{pci_scan_bus_parented+377} <ffffffff80261c6a>{acpi_pci_root_add+650} <ffffffff80263f63>{acpi_bus_driver_init+52} <ffffffff80264df7>{acpi_bus_add+2204} <ffffffff80264f70>{acpi_bus_scan+271} <ffffffff8050b95f>{acpi_scan_init+166} <ffffffff8010c232>{init+482} <ffffffff8010f6bb>{child_rip+8} <ffffffff8010c050>{init+0} <ffffffff8010f6b3>{child_rip+0} Code: 49 8b 88 30 27 00 00 76 2a 48 b8 00 00 00 80 00 81 ff ff 48 RIP <ffffffff80120ed3>{iounmap+323} RSP <ffff810144471be8> CR2: 0000000000002730 <0>Kernel panic - not syncing: Attempted to kill init!