Mailinglist Archive: opensuse (3337 mails)

< Previous Next >
Re: [SLE] WIRELESS CARD SET UP
  • From: "Joe Morris (NTM)" <Joe_Morris@xxxxxxx>
  • Date: Thu, 13 Apr 2006 06:57:28 +0800
  • Message-id: <443D85D8.3020402@xxxxxxx>
Maura Edeweiss Monville wrote:
> Here is the answer to your question:
>
>
> mauede@linux:~> /sbin/route -n
> Kernel IP routing table
> Destination Gateway Genmask Flags Metric Ref Use
> Iface
> 131.225.92.0 0.0.0.0 255.255.255.0 U 0 0 0
> eth0
> 131.225.94.0 0.0.0.0 255.255.254.0 U 0 0 0
> eth1
> 169.254.0.0 0.0.0.0 255.255.0.0 U 0 0 0
> eth0
> 127.0.0.0 0.0.0.0 255.0.0.0 U 0 0 0 lo
> 0.0.0.0 131.225.92.200 0.0.0.0 UG 0 0 0
> eth0
>
>
OK, as I suspected, the gateway is setup by DHCP running on eth0. Is
your ethernet also still plugged in?
> How and where (YAST ?) can I set both network adapters to
> STARTMODE=ifplugd (IIRC) ?
>
OK, go to Yast, Network Devices, Network Card, Hit Change in the section
of Already Configured Devices, Click on your devices and the Edit, Go to
Advanced, Detailed Settings, and choose Device Activation at Cable
Connection. You can check by going to System, etc/sysconfig Editor,
Hardware, Network, <adapter ID>, STARTMODE. Just this last weekend I
reinstalled 9.3 on my daughter's laptop, and noticed the same. Even
though ifplugd is not a listed choice, that was what her ethernet was
set to, and I was wanting ifplugd to control both, and that fixed this
exact problem for hers. HTH.


--
Joe Morris
Registered Linux user 231871






< Previous Next >