Mailinglist Archive: opensuse (3644 mails)

< Previous Next >
Installation problems with COMPAQ Proliant 800
  • From: "Mr. Tagoon Manaso" <mtagoon@xxxxxxxxxxxxxxxx>
  • Date: Fri, 15 Mar 2002 13:12:43 +0700 (ICT)
  • Message-id: <Pine.LNX.4.33.0203151311170.3832-100000@xxxxxxxxxxxxxxxx>

Hi all,

I'm unable to install SuSE 7.3 that I've downloaded from FTP SuSE Server
on my COMPAQ Proliant 800. It has a scsi port(53c875) connected to two
scsi harddisks(Seagate 4GB x 2). I'm unable to use the scsi harddisks
because they could not mount their partitions(sdax and sdbx). I tried to
load modules from "Load SCSI modules" menu in yast1 such as sym53c8xx,
ncr53c8xx and 53c7,8xx. Yast1 showed a message like "Module 'sym53c8xx'
loaded successfully!"(no parameter for sym53c8xx) for sym53c8xx module
but another modules, yast1 showed a message like "Failed to load module".
After loaded sym53c8xx module, there was a kernel messages like this :


sym53c8xx : at pci bus 1, device 4, function 0
sym53c8xx : 53c875 detected
sym53c875-0 : rev 0x3 on pci bus 1 device 4 function 0 irq 10
sym53c875-0 : ID 7, Fast-20, Parity Checking
scsi0 : sym53c8xx-1.7.3c-20010512
sym53c875-0-<0,*> : FAST 20 WIDE SCSI 40.0 MB/S (50.0 ns, offset 15)
sym53c875-0 : SCSI parity error detected : SCR1=1 DBC=11000070 SBCL=ae
sym53c875-0 : SCSI parity error detected : SCR1=1 DBC=1100002e SBCL=ae
sym53c875-0 : SCSI parity error detected : SCR1=1 DBC=1100002e SBCL=ae
sym53c875-0 : SCSI parity error detected : SCR1=1 DBC=1100002e SBCL=ae
scsi0 : channel 0 target 0 lun 0 request sense failed, performing reset.
SCSI bus is being reset for host 0 channel 0
sym53c8xx_reset : pid=0 reset_flag=1 serisl_number=0
serial_number_at_timeout=0
scsi0 : device driver called scsi_done() for a synchronous reset
sym53c875-0-<0,*> : FAST 20 WIDE SCSI 40.0 MB/S (50.0 ns, offset 15)
....................................................................
....................................................................
...................................................................


When I tried to start installation from harddisk, yast1 could not
mount the harddisk partition. I think somthing needs to be configured
somewhere. Any ideas?


Thanks in advance,
mtagoon


< Previous Next >
This Thread
  • No further messages