http://bugs.freedesktop.org/show_bug.cgi?id=15478
--- Comment #5 from Tyson Whitehead 2008-05-18 10:13:41 PST ---
I just tried the latest git (2008-05-18 up to and including commit starting
with 2ea7cdd7), and the following issues have all now been resolved:
1- Ones that were present only if an external monitor was plugged into the VGA
port before and when XOrg was starting up:
a) I used to loose my ability to switch to a virtual terminal (ctrl+alt+F1
would just give a blank screen).
b) The latop display used to remain dark on any subsequent restarts of Xorg
(without rebooting the latop) unless the external monitor was re-plugged into
the VGA port before the restart.
2- The colours on a monitor plugged into the VGA port used to sometimes look
like they had all been randomly mapped around unless the display was plugged
into the VGA port before and when XOrg was started (note -- this didn't always
happen, so it still might not be fixed, but I believe it is as I haven't seen
this once since upgrading).
Still remaining is:
1- If I unplug an external monitor from the VGA port without first disabling it
with xrandr, it then begans to report bogus DVI information:
Screen 0: minimum 320 x 200, current 1920 x 1200, maximum 1920 x 1920
VGA_1 disconnected 1920x1200+0+0 519mm x 324mm
PANEL connected 1680x1050+0+0 444mm x 277mm
1680x1050 60.1*+
DVI-D_1 disconnected
1920x1200 (0x46) 154.0MHz
h: width 1920 start 1968 end 2000 total 2080 skew 0 clock 74.0KHz
v: height 1200 start 1203 end 1209 total 1235 clock 60.0Hz
I can then get rid of by running 'xrandr --output VGA_1 --off':
Screen 0: minimum 320 x 200, current 1680 x 1050, maximum 1920 x 1920
VGA_1 disconnected
PANEL connected 1680x1050+0+0 444mm x 277mm
1680x1050 60.1*+
DVI-D_1 disconnected
2- The VESA driver reports EDID information for the laptop display, however,
the radeonhd driver is unable to obtain it. I've attached a new xorg log file
showing this again.
3- If I plug an external monitor into the HDMI port (through a HDMI -> DVI
cable), either before or after starting Xorg, nothing happens on the computer
end (xrandr report nothing and nothing shows up in the Xorg logs). I've
repeated the rhd_conntest thing:
a) With no external monitors plugged in to any of the ports:
rhd_conntest: v1.2.1, git branch master, commit 2ea7cdd7 + changes
Checking connectors on 0x9581, 0x103C, 0x30DF (@01:00:00):
Load Detection: RHD_OUTPUT_NONE
HotPlug: RHD_HPD_NONE
DDC: RHD_DDC_NONE
b) With only an external monitor plugged into the VGA port:
rhd_conntest: v1.2.1, git branch master, commit 2ea7cdd7 + changes
Checking connectors on 0x9581, 0x103C, 0x30DF (@01:00:00):
Load Detection: RHD_OUTPUT_DACA
HotPlug: RHD_HPD_NONE
DDC: RHD_DDC_0
c) With only an external monitor plugged into the HDMI port (HDMI -> DVI
cable):
rhd_conntest: v1.2.1, git branch master, commit 2ea7cdd7 + changes
Checking connectors on 0x9581, 0x103C, 0x30DF (@01:00:00):
Load Detection: RHD_OUTPUT_NONE
HotPlug: RHD_HPD_1
DDC: RHD_DDC_1
Thanks again to you guys for all their hard work on this!
Cheers! -Tyson
--
Configure bugmail: http://bugs.freedesktop.org/userprefs.cgi?tab=email
------- You are receiving this mail because: -------
You are the QA contact for the bug.
_______________________________________________
xorg-team mailing list
xorg-team@lists.x.org
http://lists.x.org/mailman/listinfo/xorg-team
--
To unsubscribe, e-mail: radeonhd+unsubscribe@opensuse.org
For additional commands, e-mail: radeonhd+help@opensuse.org