Mailinglist Archive: radeonhd (699 mails)

< Previous Next >
Re: [radeonhd] Problems with radeonhd-driver on GeCube Radeon HD 2400PRO AGP
  • From: Luc Verhaegen <libv@xxxxxxxxx>
  • Date: Thu, 29 Nov 2007 17:31:33 +0100
  • Message-id: <20071129163133.GA21120@xxxxxxxxx>
On Wed, Nov 28, 2007 at 05:00:08PM +0100, Boris Kleibl wrote:
Today I tried the latest version of radeonhd from git. I wanted to setup
a big desktop consisting of 2 monitors: Sony CPD-E400E CRT at
DVI-I_1/analog (DVI-connector) and IBM T56A TFT at DVI-I_2/analog
(VGA-connector). The configuration as shown in the attached
xorg.conf-file failed. Only the IBM-TFT starts, but the Sony-CRT goes to
power saving mode. Now I tried to invert the configuration: IBM-TFT -->
DVI-I_1/analog, Sony-CRT --> DVI-I_2/analog. Now the Sony-CRT shows a
picture and the IBM-TFT goes to power saving mode. Finally I tried the
Sony-CRT alone at each connector, definitely at DVI-I_1/analog it
doesn't show a picture.
What's going wrong? I send you my Xorg.0.log, xorg.conf and the dump of
my VGA-BIOS.

Boris

(II) PCI: 01:00:0: chip 1002,94c4 card 18bc,0028 rev 00 class 03,00,00 hdr 00

(WW) RADEONHD(0): Unknown card detected: 0x94C4:0x18BC:0x0028.

(II) RADEONHD(0): Connector[0] {RHD_CONNECTOR_DVI, "SINGLE_LINK_DVI_I DFP1
CRT2", RHD_DDC_1, RHD_HPD_1, { RHD_OUTPUT_TMDSA, RHD_OUTPUT_DACB } }
(II) RADEONHD(0): Connector[1] {RHD_CONNECTOR_TV, "7PIN_DIN TV1 CV",
RHD_DDC_0, RHD_HPD_NONE, { RHD_OUTPUT_DACB, RHD_OUTPUT_NONE } }
(II) RADEONHD(0): Connector[2] {RHD_CONNECTOR_DVI, "DUAL_LINK_DVI_I CRT1
DFP2", RHD_DDC_0, RHD_HPD_0, { RHD_OUTPUT_LVTMA, RHD_OUTPUT_DACA } }

So... Another broken connector table. Another board vendor buggering up.

Can you send us a copy of your bios by using rhd_conntest?

Thanks,

Luc Verhaegen.
SUSE/Novell X Driver Developer.
--
To unsubscribe, e-mail: radeonhd+unsubscribe@xxxxxxxxxxxx
For additional commands, e-mail: radeonhd+help@xxxxxxxxxxxx

< Previous Next >
Follow Ups