It appears that everything is setup, but I have no network access. ping or traceroute do not work. wlan0 IEEE 802.11bg ESSID:"dlink" Mode:Managed Frequency:2.432 GHz Access Point: 00:18:E7:CB:B2:20 Bit Rate=36 Mb/s Tx-Power=20 dBm Retry long limit:7 RTS thr:off Fragment thr:off Encryption key: foo Power Management:off Link Quality=70/70 Signal level=-38 dBm Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0 Tx excessive retries:0 Invalid misc:0 Missed beacon:0 linux-nxy3:~ # ifup wlan0 wlan0 name: RTL8187B_WLAN_Adapter wlan0 warning: WPA configured but may be unsupported wlan0 warning: by this device wlan0 warning: wpa_supplicant already running on interface DHCP4 client is already running on wlan0 IP address: 192.168.0.103/24 This is from the router. It shows that the USB WiFI card is connected, but no network activity with the wireless USB card in OpenSuSE. Wireless LAN Wireless Radio : Enabled 802.11 Mode : Mixed 802.11n, 802.11g and 802.11b Channel Width : 20MHz Channel : 5 Secondary Channel : WISH : Active Wi-Fi Protected Setup : Enabled/Configured Guest Wi-Fi Protected Setup : Enabled/Not Configured SSID List Network Name (SSID) Guest MAC Address Security Mode dlink No 00:18:e7:cb:b2:20 WPA/WPA2 - Personal If I plug the USB WiFI into a Ubuntu Laptop it works with no problems. There must be something else I have to do? I have gone into YaST network setup and added DHCP support. -- To unsubscribe, e-mail: opensuse+unsubscribe@opensuse.org For additional commands, e-mail: opensuse+help@opensuse.org