Claudio M. wrote:
Are the right drivers being loaded? Are the right drivers in your initrd? I guess you can't show us thee dmesg output - Yes, i can :)
Perfect! I didn't realise you had a serial console. [snip]
SCSI subsystem initialized FATAL: Error inserting processor (/lib/modules/2.6.27.7-9-default/kernel/drivers/acpi/processor.ko): No such t ice WARNING: Error inserting processor (/lib/modules/2.6.27.7-9-default/kernel/drivers/acpi/processor.ko): No suce FATAL: Error inserting thermal (/lib/modules/2.6.27.7-9-default/kernel/drivers/acpi/thermal.ko): Unknown symb) Uniform Multi-Platform E-IDE driver
Somewhere around I would have expected to see messages about your PATA CF drive being found. Something like this: ide: Assuming 33MHz system bus speed for PIO modes; override with idebus=xx AMD5536: IDE controller at PCI slot 0000:00:14.2 AMD5536: chipset revision 1 AMD5536: not 100% native mode: will probe irqs later AMD5536: 0000:00:14.2 (rev 01) UDMA100 controller AMD5536: neither IDE port enabled (BIOS) Probing IDE interface ide0... hdb: TRANSCEND, ATA DISK drive Probing IDE interface ide1... ide0 at 0x1f0-0x1f7,0x3f6 on irq 14 hdb: max request size: 128KiB hdb: 3988656 sectors (2042 MB) w/1KiB Cache, CHS=3957/16/63 hdb: hdb1
Waiting for device /dev/sda1 to appear: ..............................Could not find /dev/sda1.
hmm. I think the problem is that the drivers needed for your CF card aren't being loaded.
I think this too, but i don't know wich driver
Is there any way you can provide the output from 'lspci' on this board? I've googled a bit, and I have seen the IDE interface mentioned as AMD5536 - does that fit your board?
From /etc/sysconfig/kernel, what does your INITRD_MODULES look like?
/Per -- Per Jessen, Zürich (16.4°C) -- To unsubscribe, e-mail: opensuse+unsubscribe@opensuse.org For additional commands, e-mail: opensuse+help@opensuse.org