Hi, One of my PCs at home has a Ralink RT2561 PCI wireless card. I configured it following several suggestions on this list, and now the card works like a charm. What I did was remove the rt2x00 driver that's shipped with the install CD, and instead used the rt61-cvs drivers on the schmolle1980 repos. In the past, I've always used that driver on other distros (Slackware and Arch), and it worked very well. This afternoon I wanted to install openSUSE 10.3 on my main machine at work, which has the same RT2561 wireless card. I followed the same steps as on my home PC: remove the rt2x00 driver, configure the schmolle1980 repos, install rt61-cvs, reboot (to be sure old modules are unloaded and new modules are loaded). After rebooting, I wanted to configure the card with YaST, but curiously enough, it didn't appear. So I opened a Terminal to see what was going on. # lsmod | grep rt61 --> shows the module is loaded OK. # ifconfig -a --> shows only 'lo' and 'eth0'. No 'wlan0' # lspci --> shows the card OK (which means it's plugged in correctly) # uname -r --> shows I'm using the default kernel, just to check if the rt61-cvs is the right one, e. g. the one for the default (and not bigsmp or xen) kernel. A quick check in /lib/modules/`uname -r` shows the rt61.ko module OK. Still, 'ifconfig -a' doesn't show any wlan0 interface. Which leaves me clueless. Any suggestions? Niki -- To unsubscribe, e-mail: opensuse+unsubscribe@opensuse.org For additional commands, e-mail: opensuse+help@opensuse.org