hi list i am about to make a bootable floppy for test but i am being unable to get it done please review the code below and tell me if there is any problem with it ---------------------------------------------------------------------------------------------------------------------------------- .code16 #assembler directive to start 16-bit real mode for execution .text /*assembler directive to tell the start of 'read-only' code segment*/ .org 0x00 /*assembler directive to set the origon to sector 0 needed to copy the program to the very first sector of the floppy disk*/ .global _start /*assembler directive to export the start section to all other programs, i.e. to make it visible to programs like linker or other user programs*/ _start: #label of the start routine mov 0x07C0, %ax /*move immidiate operand 07C0 to the accumulator register ax, so that it can be transfered to data segment register*/ mov %ax, %ds /*move contents of register ax to register ds*/ call _boot #call the boot section ret #return the control to the caller routine _boot: #label of the boot section mov $msg, %si /*move the address of the character string constant 'msg' to the source index register*/ call _disp #call subroutine disp ret #return the control to the caller routine _disp: #label of the disp routine cld /*clear direction flag, to permit string instructions to increment index registers by their own*/ lodsb /*load the string pointed by ds:si in a byte by byte manner into the accumulator*/ or %al, %al /*check if the entire string has been loaded byte-wise by oring al to al, if the result is zero, it shows there are no more byte to load*/ jz ret #jump if al zero to return mov $0xE, %ah /*else put code for 'write a character on the screen and move forward' into the ah*/ mov $7, %bh /*enable normal attribute for all the blank lines on the screen*/ int $0x10 /*call interupt 0x10, which is responsible for the video display, it will take codes from ah and bh*/ jmp _disp msg: #label of the string definition .ascii "My Boot System" #definition of the string .org 510 #set origon to 510 .word 0xAA55 # -------------------------------------------------------------------------------------------------------------------------------------- saved the file with the name myos.s then #as myos.s -o myos.o #objcopy -O binary myos.o BOOT #dd if=./BOOT of=/dev/fd0 bs=512 count=1 ------------------------------------------------------------------------------------------------------------------------------------- the system tries to boot from the floppy and it boots (as it doesnt give an error or it doesnt go to the next boot device. but it doesnt display the string that i had to show from the string please check it and tell me about any possible errors in the code Regards Azeem _________________________________________________________________ Express yourself instantly with MSN Messenger! Download today it's FREE! http://messenger.msn.click-url.com/go/onm00200471ave/direct/01/ -- To unsubscribe, e-mail: opensuse+unsubscribe@opensuse.org For additional commands, e-mail: opensuse+help@opensuse.org