Hi all, I am quite new to Xen, but a bit used with Linux in general. I just wonder how to setup domU network. I use the Xen embeded in opensuse 10.2. My real network, without any Xen consideration is about one desktop and one laptop, behind a modem-router that NATs too. The modem-router-NATer offers LAN IP address via DHCP. I acces internet through the eth1 but I have an unused eth0. Therefore, I specified eth1 as 'network-brige net-dev' in xend-config.sxp. I only consider full virtualization (running non-modified OS), I have the VT CPU to so so. I first tried to install a Debian netinst. The "problem" is the debian installer first look at a DHCP offer. It fails. Then, I guess I have to make it static address: but what kind of IP address? I dont know what's the default IP range, or where is it set up. OTOH, what should be the gateway address? the modem-router-NATer one's? Finally, should I or not use: # (network-script network-nat) # (vif-script vif-nat) Given my working interface is eth1, should I apply any netdev=eth1 in there? For the moment, they're all commented out. Thank you for your help. -- To unsubscribe, e-mail: opensuse+unsubscribe@opensuse.org For additional commands, e-mail: opensuse+help@opensuse.org