If I try to install RC1 there are errors. PCI: Bus 8, cardbus bridge: 000:03:04.1 IO window: 00003c99-00003cff IO window: 00002400-000024ff PREFETCH window:32000000-33ffffff MEM window: 38000000-39ffffff PCI: Bridge: 0000:00:1e.0 IO window: 3000-3fff MEM window: d2000000-d20fffff PREFETCH widnow: 30000000-34ffffff PCI: Found IRQ 11 for device 0000:03:04.0 PCI: Assigned IRQ 10 for device 0000:03:04.1 NET: Registered protocol family 2 or PCI: Setting latency timer of device 0000:00:1e.0 to 64 ACPI: PCI Interrupt Link [LNKE] enabled at IRQ 11 PCI: setting IRQ 11 as level-triggered ACPI: PCI Interrupt 0000:03:04.0[A] -> Link [LNKE] -> GSI 11 (level, low) -> IRQ 11 ACPI: PCI Interrupt Link [LINKF] enabled at IRQ 10 PCI: setting IRQ as level-triggered ACPI: PCI Interrupt 0000:03:04.1[B] -> Link [LINKF] -> GSI (level, low) -> IRQ 10 NET: Registered protocol family 2 I already tried to boot with acpi=off etc. But it does not work. Yesterday i looked what 03:04.1 is: 03:04.1 Card bridge: Texas Instruments PCI7420 Card Controller. I have no idea, what i can do :-/ SuSE 10.0 and 10.1 works fine on this notebook -- To unsubscribe, e-mail: opensuse+unsubscribe@opensuse.org For additional commands, e-mail: opensuse+help@opensuse.org